5.0TONKAFLO PUMP FIELD MAINTENANCE
5.1Motor Bearing Lubrication
Motors up to 3 Hp typically have sealed bearings. Motors of 5, 7.5, and 10 Hp may or may not have sealed bearings. For these larger motors, lubrication intervals vary between manufacturers but generally lubrication every 2000 hours is required. Consult Your Local Motor Distributor For Lubrication Advice, or the motor information supplied with your pump.
5.2Motor Removal: XB and XC Motor Adapter Pumps
STEPS
1.Disconnect the motor electrical power.
2.Remove the wiring to the motor.
3.Remove the piping from the pump.
4.Remove the pump mounting bolts, and place the pump on a work bench.
5.Remove the
6.Remove the four (4)
7.Slide the liquid end assembly away from the motor adapter 1/4- to
8.Use two (2)
9.Remove the four (4)
10.Loosen the two set screws that hold the shaft coupler to the motor shaft, and remove the shaft coupler. The motor may now be serviced by a qualified ven- dor or replaced (Figure 4.6, Removal of Mechanical Seal Holder from Motor Adapter).
17