Installation Instructions
Convert Natural Gas Model ZGU384NSMSS to LP Gas Operation
If sold outside the U.S. and Canada:
WARNING:If you wish to use this product with Liquefied Petroleum (LP) gas containing greater than 10% butane, you must purchase the butane conversion kit #WB28T10238. To order, please call 1.888.664.8403 or 1.787.276.4051.
SAFETY INFORMATION
The pressure regulator and burner orifices are set for natural gas operation.
To convert this cooktop from natural gas operation to LP operation, the regulator and burner orifices must be
1ADJUST THE REGULATOR
A.Disconnect all electrical power, at the main circuit breaker or fuse box.
B.Shut off the gas supply to the cooktop by closing the manual
C.Adjust the pressure regulator by the following instructions:
•Unscrew the cap.
•Place your thumb against the flat side of the spring retainer and press down to remove the retainer.
•Carefully look at the spring retainer to locate the NAT or LP position.
Cap Gasket
converted. LP burner orifices are attached to the regulator.
CAUTION
WARNING —This conversion must be
LP
NAT
LP
NAT
NAT.
position
NAT
LP
| Spring |
NAT | retainer |
LP |
|
L.P./propane position
OFF FOR
DOWN
performed by a qualified installer or gas supplier in accordance with the manufacturer’s instructions and all codes and requirements of the authority having jurisdiction. Failure to follow instructions could result in serious injury or property damage. The qualified agency performing this work assumes responsibility for the conversion.
CAUTION
TOOLS YOU WILL NEED FOR
CONVERSION
Crescent wrench | 7mm nutdriver |
| Small |
Safety glasses | screwdriver |
(2 to 2.4 mm or | |
| 3/32″ tip size, |
| 60 mm long) |
15
Pressure regulator
•Turn the spring retainer over so that the desired gas is showing on the bottom.
•Snap the retainer back into position.
•Screw the cap back onto the regulator.
2 CHANGE BURNER ORIFICES
INSTALLATION TIP: First remove all | Burner cap | |||
orifices and then start replacing them. |
| |||
This will help to prevent the possibility |
| |||
that some may not be replaced. | Burner |
| ||
A. Remove the burner grates, |
| |||
head |
| |||
burner caps and burner heads. |
| |||
B. Using a 7mm nut driver, remove the |
| |||
top burner orifices. There are two |
| |||
orifices per burner. |
|
| Burner | |
The main orifice is | Spark igniter | |||
base | ||||
located low in the center | ||||
|
|
| ||
of the burner, while the | Simmer | Main | ||
simmer orifice is located | orifice |
| ||
higher beside the center |
| orifice | ||
of the burner. |
|
| ||
|
|
|