Cut rail for filler panel
Cabinetry Modification Suggestions
Cut the rail out of finished material:
• The width should match cabinet opening width.
•The height of the top rail should be enough to securely attach the rail to the appearance panel, plus 1/4" oven trim overlap.
• The height of the bottom rail should be enough to securely attach the rail to the appearance panel, plus 7/8" oven trim overlap.
• The height of both the top and bottom rails should be adjusted depending upon the height of the gap to be filled or to enhance appearance.
Cut appearance panel
Determine location of cleats
Use drawer fronts for appearance panels or cut finished material and finish raw edges.
•The appearance panel width should match drawer fronts or doors.
•Make the appearance panel appropriate height to
fill the gap above or below the oven, allowing for reveals and overlaps to match existing drawers or doors.
• To find the exact position of the cleats, place the | • Use a pencil to mark the back side of the panel |
appearance panel onto the cabinet in desired | where it meets the cabinet corners. |
position and align to match the other drawers and |
|
doors. |
|
14
