GE ZMC1090BV Installation, Built-In Ovens, Tools and materials required Electrical locations

Installation

Built-In Ovens

Tools and materials required

Electrical locations

•Outlet box

•Electrical cable—3-conductor or 4-conductor wire—as required by local codes

•Flexible power cable connector

•Electrician’s pliers

Note: Do not use an extension cord with these appliances.

Monogram built-in single and double ovens require

aseparate, properly grounded 3-wire 120/208 or 120/ 240 volt, 60 Hz power supply, protected by a time delay fuse or circuit breaker. Ovens are supplied with a flexible power cable, which must be attached to a junction box. The cable length is 48" for both single and double conventional ovens. The cable length for convection type ovens is 54".

Double ovens are rated 6.8 KW at 240 volt, and 5.1 KW at 208 volt.

Single ovens are rated 3.4 KW at 240 volt, and 2.6 KW at 208 volt.

The back of the ovens have chamfered corners which provide a “chase” for the conduit when installing a junction box above or below the oven(s).

The conduit is located on the back of the oven, approximately 10" from the right side.

For double oven:

•Locate and install the junction box within reach of the power cord.

–Approximately 10" from the left side of opening

–56" minimum above the cutout floor

–or, through the left side of cabinet wall into adjacent cabinet.

For single oven:

•Locate and install the junction box within reach of the power cord.

–Approximately 10" from left side of opening.

–At least 5" below the cutout floor

–Or 34" minimum above the cutout floor

–or, through the left side of cabinet wall into adjacent cabinet.

Double Oven:	Single Oven:
Locate Junction Box	Locate Junction Box
in one of the locations	in one of the locations

16