Before you
IMPORTANT: Save these instructions for local inspector’s use.
IMPORTANT: OBSERVE ALL GOVERNING CODES AND ORDINANCES.
NOTE TO INSTALLER: Be sure to leave these instructions with the
Consumer.
NOTE TO CONSUMER: Keep these instructions with your Use and Care
Book for future reference.
WARNING | This appliance must be properly grounded. See “Electrical Supply”, page 16. |
| |
| If you have questions concerning the installa- | Proper installation is the responsibility of the | |
| tion of this product, call the GE Answer | installer. Product failure due to improper installation | |
| Center® Consumer Information Service at | is not covered under the GE Appliance Warranty. See | |
| 800.626.2000, 24 hours a day, 7 days a week. | the Use & Care Guide for warranty information. |
If you received a damaged oven, you should contact your dealer.
CAUTION:
•This oven should be installed by a qualified installer or service technician.
•Never use the oven for warming or heating a room. Prolonged use of the oven without adequate ventilation can be hazardous.
Check with local utilities for electrical codes which apply in your area. Local codes vary. Installation, electrical connections and grounding must comply with applicable codes. In the absence of local codes, the oven should be installed in accordance with National Electrical Code ANSI/NFPA
Contents | Design Information |
|
| Models Available | 3 |
| Dimensions and Clearances | 3 |
| Cabinet Style Options | 4 |
| Installation Options | 5 |
| 5 | |
| Cabinetry |
|
| Tools and Materials required | 6 |
| Framed Cabinet, Double Oven | 6 |
| Framed Cabinet, Single Oven | 7 |
| Recessed Installation: Front framed cabinets with inset doors and drawers | 8 |
| Frameless Cabinets | 9 |
| Single Oven Installed Below a Microwave Oven | 10 |
| Single Oven Installed Below a Countertop | 11 |
| Cabinetry Modification Suggestions |
|
| Provide Oven Supports | 12 |
| Install Oven Supports | 12 |
| Determine Need for Filler Panels | 13 |
| Filler Panel Construction | 13 |
| Cut Rail for Filler Panel | 14 |
| Cut Appearance Panel | 14 |
| Determine Location of Cleats | 14 |
| Cut and Secure Cleats to Filler Panel | 15 |
| Secure Rail to Appearance Panel | 15 |
| Secure Assembled Filler Panel to Cabinet | 15 |
| Installation |
|
| Tools and Materials Required | 16 |
| Electrical Locations | 16 |
| Finalize Installation | 17 |
| Route Cable Through Cutout | 17 |
| Secure Oven to Cabinet | 18 |
| Replace the Oven Door | 18 |
| Connect Electrical | 18 |
2