Questions? Use this problem solver!
|
| The Problem Solver | ||
|
|
|
|
|
|
|
| Custom Hood Insert | |
|
|
|
|
|
| PROBLEM | POSSIBLE CAUSE | ||
| FAN AUTOMATICALLY | • The Sensor feature will automatically turn the fan on at the | ||
| TURNS ON AND CAN | MED setting if cooking temperatures become too hot . The fan | ||
| NOT BE TURNED OFF | will stay on for a minimum of 3 minutes and will then turn off when | ||
|
| temperatures cool to an appropriate level. | ||
|
|
|
|
|
| FAN DOES NOT | • A fuse may be blown or a circuit breaker tripped. Replace fuse or | ||
| OPERATE WHEN | reset circuit breaker. | ||
| TURNED ON | • The power disconnect switch inside the hood may be switched off. | ||
|
| Remove the metal grease filters and flip the switch on. | ||
|
|
|
|
|
| FAN FAILS TO CIRCULATE | • Check to be sure the metal grease filters are clean. Clean the metal | ||
| AIR OR MOVES AIR | grease filters (see the Metal grease filters section). If cleaning | ||
| SLOWER THAN NORMAL | the filters does not correct the problem, call for service. | ||
|
|
|
|
|
| FAN KEEPS GOING | • The motor is probably overheating and turning itself off. This can | ||
| OFF AND ON | be harmful to the motor. Check to be sure the filters are clean. If off | ||
|
| and on cycling continues, call for service. | ||
|
|
|
|
|
| LIGHT WILL NOT STAY | • Use 120 volt, 50 watt halogen bulbs with a GU10 base and make sure | ||
| ON HIGH SETTING | they are inserted securely. See the Light bulbs section. | ||
|
|
|
|
|
| THE HOOD CONTROLS | • Disconnect power to the hood by removing the fuse or turning the | ||
| ARE NOT OPERATING | circuit breaker off in the home fuse box. Wait 30 seconds to allow the | ||
| CORRECTLY | hood controls to reset and then replace the fuse or move the circuit | ||
|
| breaker back on. | ||
|
|
|
|
|
| SEQUENTIAL PRESSES | • It is normal for the light and fan buttons to cycle around through the | ||
| OF THE LIGHT OR FAN | settings so that you can easily set the controls to the desired setting. | ||
| BUTTONS WILL |
|
|
|
| SOMETIMES CHANGE |
|
|
|
| THE SETTING FROM THE |
|
|
|
| LOWEST |
|
|
|
| TO THE HIGHEST SETTING, |
|
|
|
| OR FROM THE HIGHEST |
|
|
|
|
|
|
| |
| LOWEST SETTING |
|
|
|
|
|
|
|
|
| WHEN PRESSING THE | • For your convenience, it is normal for the lights and fan to remember | ||
| POWER ON/OFF BUTTON | their last setting when you press the Power On/Off button. If you | ||
| TO TURN ON THE LIGHT, | want only the lights on, press the “FAN +” (or the “FAN | ||
| THE FAN COMES ON | the fan is off. When you power the hood up next time, only the lights | ||
| INSTEAD | will function. | ||
|
|
|
|
|
8