GE Monogram Range Installation, Install Anti-Tip Device, Anti-Tip Parts Provided

Installation

STEP 3 INSTALL ANTI-TIP DEVICE

• All ranges can tip.

• BURNS or other SERIOUS INJURIES can result.

• INSTALL and CHECK the ANTI-TIP bracket following these instructions.

To reduce the risk of tipping the range, the range

must be secured by a properly installed anti-tip bracket. See installation instructions shipped with the bracket for complete details before attempting to install.

To check if the bracket is installed and engaged properly, carefully tip the range forward. The bracket should stop the range within 4 inches. If it does not, the bracket must be reinstalled.

If the range is pulled from the wall for any reason, always repeat this procedure to verify the range is properly secured by the anti-tip bracket.

If your range has no anti-tip bracket, call 1.800.626.8774 to receive one at no cost.

If the Anti-Tip device supplied with the range does not fit this application, use the universal Anti-Tip device WB2X7909.

Read the AHAM Anti-Tip Safety Brochure packed with the bracket.

Anti-Tip Parts Provided

4 Wood Screws Anti-Tip Bracket

3 Hex Head Screws (2 required, 1 extra)

Anti-Tip Brace

AHAM Anti-Tip

Safety Brochure

•Attach the Anti-Tip Brace onto the bottom

of the range in the recessed area. Install 2 hex screws (provided) through the brace and into the range.

NOTE: This Anti-Tip device may be installed on the opposite side of the range.

Hex Screws

Anti-Tip Brace

Alternate Brace

Position

•Measure and mark Dimension A (see table below) from the left (or right) side of the installation location. If the countertop has an overhang, add that dimension to Dimension A.

•Place the Anti-Tip Bracket against the floor

and back wall at the marked location. Mark screw holes for fastening the bracket to the wall sole plate and the floor.

•Drill 1/8" pilot holes at a 20° angle.

•Secure the bracket to the wall and/or floor with at least 2 wood screws (provided).

For Concrete or Cement Construction: You must use appropriate fastening hardware (not provided).

Range	A	Anti-Tip Bracket
30”	5-1/16”
36”	5-1/16”	Wall Sole Plate
48”	8-1/4”

A

13