GE Monogram Range Installation Instructions for Gas Conversion, CHANGE BURNER ORIFICES cont, Main

Installation Instructions for Gas Conversion

3 CHANGE BURNER ORIFICES (cont.)

IMPORTANT: Find your model number below. Read each orifice label to identify and install them in the exact locations shown.

ZDP304 SIMMER ORIFICES

A 34SL or 51SN orifice

will be used on all burners.

4 CHANGE GRILL ORIFICE (if present)

Locate the 1–1/2” long Grill orifice.

Select for your gas type. LP—.047, NAT—.067

A. Remove the grill cover, grates and grate frame. Lift the radiant baffle straight up and off.

ZDP304 MAIN ORIFICES

A 84XL or 126HXN orifice will be used on these three burners.

Use a 108XL

or 190XN orifice for the right front burner.

B. Remove the 2 hex
head screws from	Remove 2
the top of the igniter.
	hex head
• Remove one screw	screws
from each side of
the burner surround.
• Lift out the surround.		Surround
		Screws
	Burner	Igniter

ZDP364, ZDP366, ZDP484, ZDP486

SIMMER	A 34SL or 51SN orifice
ORIFICES	will be used on all
	burners.

MAIN	Use 108XL or
ORIFICES	190XN orifices
	for all burners.

A. Return the unused orifices to the holder. Reattach the holder and the instruction sheet with screw in the original storage location.

B.Replace the burner heads, caps and top grates. On range models, replace rear vent trim.

C. Carefully push the	Surround
igniter aside and
under
the burner.
Do not pull or pinch
the wire.	Burner
Remove 4 burner	Assembly
attachment screws,
2 at the front and 2
at the back. Slide the
burner assembly
toward the back and
out of the gas inlet.
D. Use a 1/2" deep well	Front of Range
socket to remove

and replace the orifice .

Reverse these

steps to re-assemble the grill. Be sure to place the unused orifice in the holder for possible future use.

22