GE Monogram Range Design Information, Contents, Models Available, Backsplash Accessories

Design Information

CONTENTS
Design Information
Models Available	3
Backsplash Accessories	3
Product Dimensions and Clearances	4-7
Tools and Materials Required	8
Installation Preparation
Power Supply Locations	9, 10

Installation Instructions
Step 1, Remove Packaging	11
Step 2, Move Range Indoors	12
Step 3, Install Anti-Tip Device	13
Step 4, Connect Range to Gas	14
Step 5, Connect Electrical	14
Step 6, Roll Range into Position	14
Step 7, Level the Range	15
Step 8, Replace Oven Doors	15
Step 9, Check Burners	16
Finalize Installation	16
Installation Checklist	16
Accessories	17
Accessory Installation	18–20
Gas Conversion	21-23

MODELS AVAILABLE

These Monogram ranges are factory set for either natural gas or LP gas. Order the model for your installation situation.

48" Natural Gas Models:

ZDP484NG – 4 gas burners, grill and griddle ZDP486NR – 6 gas burners and grill ZDP486ND – 6 gas burners and griddle

48" LP Gas Models:

ZDP484LG – 4 gas burners, grill and griddle ZDP486LR – 6 gas burners and grill ZDP486LD – 6 gas burners and griddle

36" Natural Gas Models:

ZDP366N – 6 gas burners ZDP364NR – 4 gas burners and grill ZDP364ND – 4 gas burners and griddle

36" LP Gas Models:

ZDP366L – 6 gas burners ZDP364LR – 4 gas burners and grill ZDP364LD – 4 gas burners and griddle

30" Natural Gas Model: ZDP304N

30" LP Gas Model: ZDP304L

BACKSPLASH ACCESSORIES

All models require 12" minimum clearance to a vertical combustible surface at the rear. If clearance is less than 12”, the entire surface of the back wall above and the full width of the range must be protected by a backsplash. The backsplash must be constructed of non-combustible material, such as metal, ceramic tile, brick, marble or other stone.

Two Backsplash Accessories Available:

•The 12" high stainless steel backsplash accessory is available. Use this backsplash in combination with a custom, non-combustible backsplash built beyond the 12” height. The combined height of the backsplash accessory and the custom backsplash must reach the bottom of a hood, or when there is no hood, to 48” above the cooking surface.

•An adjustable 30" to 36" high backsplash with shelf is also available. This backsplash fills in the space between the top of the range and the bottom of the hood. The shelf is positioned so that heat lamps from the bottom of a Monogram professional hood are directed towards the shelf.

12" High Backsplash ZX12B48PSS, for 48" wide ranges ZX12B36PSS, for 36" wide ranges ZX12B30PSS, for 30" wide ranges

30" to 36" Adjustable Height Backsplash With Shelf ZXADJB48PSS, for 48" wide ranges ZXADJB36PSS, for 36" wide ranges ZXADJB30PSS, for 30" wide ranges

3