Electronic ignitors
NOTE: Keep the ignitor, ignitor cap and burner ports clean.
If a burner does not ignite, listen for the |
|
clicking sound. If the ignitor is not clicking, |
|
turn off the burner. Check the circuit breaker |
|
for a blown fuse or a tripped circuit breaker. If |
|
the ignitor still fails to operate, check the |
|
Problem Solver in the back of this guide or the | Simmer |
Power Failure information in this section. | ignition |
NOTE: If you are using propane gas, a slight pop | channels |
| |
or flash may occur at the burner ports a few |
|
seconds after the burner has been turned off. |
|
This “extinction pop” is normal for propane gas. |
|
Ignitor
Burner base
Simmering
Your new professional gas range has exceptionally low simmering capabilities. The center simmer cap serves as a heat diffuser to spread out the heat to avoid having a center hot spot. Keep in mind that because of the high heat capacity of the outer burner, and the mass of the cast iron burner grates (they retain heat longer than lighter, conventional grates), some foods may continue to cook by retained heat after the burner has been turned off.
The simmer burner is lit from the outside burner flame.
The flame travels through the simmer ignition channels and crosses over onto the simmer burner located just beneath the simmer cap. When lighting only the simmer burner, always light the main burner first. This will in turn provide the ignition source for the simmer burner. Ensure that the simmer ports are lit before turning the control knob down to the simmer position. Should a strong draft or boilover extinguish the simmer flame it will not relight automatically as the outer burner would.
Burner efficiency and flame characteristics
The burner flame should burn completely around and within the burner with no excessive noise or lifting. The flame should be blue in color and stable with no yellow tips.
An improper
A technician should adjust the flame.
During initial use, foreign particles in the gas line, or dust in the air or around the appliance may cause an orange flame. This will disappear with use.
Power failure
The electric ignition that lights the surface burners will not operate during a power failure.
To light the surface burners during a power failure, turn the control knob for the burner you want to light to LITE while holding a lighted match to the outer ring.
After the flame is burning all the way around the burner, adjust the flame.
It is necessary to light each burner separately each time you want to use it during a power failure.
11
