GE Monogram ZBD0710 Illuminate at the end, Cycle Anti-Bacteria, Cycle only, Interior lights not

Questions? Use this problem solver

Before You Call For Service

		Dishwasher
PROBLEM	POSSIBLE CAUSE	WHAT TO DO
Sanitized light does not	The door was opened and	• Do not interrupt the cycle any time during
illuminate at the end of	the cycle was interrupted	or after main wash.
the cycle (Anti-Bacteria	during or after the main
cycle only)	wash portion
	Low inlet water	• Raise the water heater temperature to
	temperature	at least 120°F (49°C).
Interior lights not	Door was open for more	• Latch the door and reopen.
working	than 15 minutes
	Bulbs are burned out	• Call for service to replace bulbs.
End-of-cycle indicator	Dishwasher has not	• Open the door and check the status
light does not illuminate	completed cycle	indicator lights on control panel to
		determine if cycle is complete.
Beeps every 30 seconds	Door was opened	• Close the door to complete the cycle.
	during the cycle
START/RESET light blinks	START/RESET pad was	• Dishwasher will pump out for approximately
	pressed during the cycle	70 seconds and blinking light will turn off.
	Power failure during	• Dishwasher will pump out for approximately
	the cycle	70 seconds and blinking light will turn off.
		Dishwasher will automatically restart using
		NORMAL WASH and HEATED DRY.

19