Step 3 Positioning the compactor backstop

Step 4 Setting the height

 

 

 

 

 

 

 

 

Installation

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Built-In Compactors

 

 

 

 

 

 

 

 

 

 

 

A backstop should be installed to prevent the

 

 

 

 

 

 

 

 

 

compactor from “walking” back when the drawer

 

 

 

 

 

 

 

 

 

is closed.

 

 

 

 

 

 

 

 

 

Measure and mark 16" back from the front edge of

 

Note: If using a custom toekick, add that

 

the cabinet toekick. Cut a 2x4, 10" long and anchor

 

thickness to the 16" measurement.

 

to the floor.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Measure height “B” from the underside of the countertop to the floor where the compactor will be setting.

With the compactor still laying on its back, adjust leveling feet to 1/16" less than the measurement of “B”. Place the plastic leveling feet caps over the leveling feet and stand compactor upright.

9

Page 9
Image 9
GE Monogram ZCG3500, ZCG3100, ZCG3300 installation instructions Positioning the compactor backstop Setting the height