PREPARATION
Unpacking the Icemaker
1.Lay the carton on rear face and break open the bottom flap.
2.Set the carton upright with all
four flaps outward.
3.Lift carton up and off icemaker.
4.Remove all tape and
packaging material from the outside and inside of the cabinet.
5. Remove the front grille; take | Remove | |
out the screws securing the | ||
Interior | ||
grille at the bottom and lift it | Packing | |
free of the cabinet. |
|
6.Turn the fan by hand to make certain it moves freely.
Open Bottom Flaps
Location
THIS ICEMAKER MUST BE INSTALLED IN AN AREA PROTECTED FROM THE ELEMENTS, SUCH AS WIND, RAIN, WATER SPRAY OR DRIP.
1.Place the icemaker so the front side will be completely unobstructed to provide proper air flow.
2.The area should be well ventilated with temperature above 55°F. (13°C.) and below 110°F. (43°C.). Best results are obtained between 70°F. (21°C.) and 90°F. (32°C.).
3.Provision for electricity, water and drain connections should be determined.
4.The icemaker may be closed in on the top and three sides, but the front MUST BE unobstructed for air circulation and proper operation. Installation should be such that the cabinet can be moved forward for servicing, if necessary.
Leveling
1.After placing the icemaker into position, check to make certain the icemaker is level side to side and front to back.
2.Accurate leveling is essential for proper operation.
3.The icemaker should be shimmed so that it is solid as well as level. The shims should be of hard permanent type material such as masonite.
4.Compliance with National Sanitation Foundation standards requires that this type of product be sealed to the floor at the bottom rail in order to prevent contamination from spills or the entrance of vermin. Therefore, we recommend that when installing the icemaker you seal it to the floor in accordance with those standards. A
Thermostat Calibrations
If the icemaker is installed above two thousand feet of altitude, the bin and evaporator thermostats must be adjusted to a warmer setting. Disconnect electricity, remove thermostat and follow the directions for turning the altitude adjustment screw as shown in the label on each thermostat.
(continued next page)
11
