GE Monogram ZET857SYSS, ZET837SYSS Installation, Built-In Convection Ovens, Jumper, Loosen Screws

208V Electrical supply

Single ovens, double ovens– (upper oven)

Installation

30" Built-In Convection Ovens

	WARNING	These ovens are pre-wired for connec-	If connecting to a 208 volt, 60 Hz., supply, a jumper
tion to 240 volt, 60 Hz., supply. If connecting			must be used across two terminals.
			• For double ovens, there are two jumpers, one for the
to a 208 volt supply, modifications must be made.
			upper oven, one for the lower oven.
			• For single ovens there is one jumper.

1
Jumper	2

Loosen Screws

3 4 5

Jumper

Loosen Screws

Double ovens– (lower oven)

Jumper Tighten Screws

To connect to 208 volt circuit:	• Remove the jumper and place between the first and
• Remove the access panel(s) located on the back of	second screws, tighten the screws to hold the
the ovens.	jumper in place.
• Loosen the first and second screws in the terminal	• Replace the access panel(s).
block as shown.

Double ovens–Lower

	1	2	3	4
					Loosen Screws
Jumper
	Loosen Screws				Jumper

Jumper Tighten Screws

10