Installation Instructions
INSTALLING SABBATH MODE SWITCHBOX Bottom-Freezer Refrigerators (cont.)
MAKING ELECTRICAL CONNECTIONS (cont.)
•Route the wires for the AC Connectors over the water filter. Route the wires for the DC Connectors under the door trim. If necessary, use the wire ties included with the kit to dress the wires.
NOTE: Make sure the door hinge does not pinch the wires hanging down from the switchbox when closing the door.
•Cover any exposed wiring on the refrigerator connectors with UL approved electrical tape.
WARNING: No wires are to be exposed.
•Write the installation date on the ZSAB1 switchbox.
•Place the Sabbath Mode Product Kit Technical Data Sheet with the refrigerator’s Technical Data Sheet for future use.
•Close the grille panel.
•Replace house fuses or reset circuit breaker.
Water filter
Make sure door Door trim hinge does not
pinch wires when closing the door.
OPERATION CHECKLIST
With the Sabbath Switch set to OFF:
Make sure the green LED light is off.
Listen to make sure the compressor is running.
Open the fresh food door and freezer drawer and confirm that the interior lights and the temperature display operate normally. If the interior lights do not come on, the Master Light Switch may have been accidentally set to the OFF position. Make sure the Master Light Switch is in the ON position.
With the Sabbath Switch set to ON:
Make sure the green LED light is on.
Open the fresh food door and freezer drawer to make sure the lights do not come on and the temperature display does not come on.
Listen to make sure the compressor is running.
Confirm that the kit wires are properly routed and that no AC wires are exposed at the unit connector side. Use UL approved electrical tape to cover wires completely.
Confirm that the Sabbath Mode Product Kit Technical Data Sheet has been placed with the refrigerator’s Technical Data Sheet for future use.
Confirm that the installation date has been written on the ZSAB1 switchbox.
Leave the Installation Instructions with the consumer for future use.
10
