Installation Instructions
6 CONNECT ELECTRICAL
• Verify that power is turned off at the source.
WARNING: If house wiring is not
•Insert house wiring through strain relief and tighten.
•Connect white leads to branch circuit white lead.
•Connect black leads to branch circuit black lead.
•Connect green/yellow leads to branch circuit green lead or bare ground lead.
•Secure all connections with wire nuts on each electrical connector.
•Push wires into junction box and replace cover. Be sure wires are not pinched.
7 INSTALL DUCT COVERS AND UTILITY BARS
•Separate the duct covers supplied with the hood.
•Discard the upper (inner) section.
•Insert the ZXR758 or ZXR7510 duct cover (with vent holes) into the original lower section. Be sure that the new duct section is inside the shorter original section.
Mounting Screw Holes
•Place the decorative duct covers on top of the hood.
•Insert the lower portion of the duct cover into the impressions on the top of the hood.
•Extend the inner duct upwards to meet the ceiling and support frame.
•Secure the duct cover to the frame with the 2 small Phillips screws provided.
•Install the side utility bars as shown with screws provided.
8