GE Monogram ZXR7510 Installation Instructions, Determine Installation Location, For ZXR758

Installation Instructions

1 DETERMINE INSTALLATION LOCATION

To determine the exact location of the vent hood.

•Locate the template packed with the literature.

–Measure 36" from the floor to the top of the cooking surface. Add 25-1/2" recommended space from the cooking surface to the bottom of hood. Mark that location.

–Use a level to draw a straight pencil line on the wall.

–Tape the template in position along the penciled line. CHECK TO BE SURE THE TEMPLATE IS LEVEL.

–Measure from the peak of the hood to the ceiling as indicated.

Ceiling

CL

For ZXR758 –

26-1/4" to 38-1/2" for 8 ft. to 9 ft. ceilings. For ZXR7510 –

38-1/4" to 50-1/4" for 9 ft. to 10 ft. ceilings.

•Use a level to draw a line straight up, from the centerline on the template to the ceiling.

House Wiring Locations

•The junction box is located on the top of the hood, at the front right side.

•Route house wiring as close to the installation location as possible; through the ceiling, soffit or back wall. Wiring should enter at least 4" above the bracket on the right side.

2 INSTALL MOUNTING BRACKETS

Whenever possible, the vent hood should be secured to wall studs.

•With the template taped in place, use a punch to mark all mounting screw locations.

•Drill 1/8" pilot holes at the 6 punched locations.

•Remove the template.

•Enlarge holes that did not enter studs to 3/8" and tap anchors for metal wall fasteners into the holes.

–Drive screws into the fasteners to allow anchors to expand against the wall material. Remove the screws for final installation.

•Secure the mounting brackets to the wall studs with wood screws provided.

–For hollow walls, secure the mounting brackets through the anchors.

	Screws
	“B”
Note: Screws “A” and	Screws
“B” are pre-assembled
onto the brackets. Do	“A”
not remove these
screws.

6