RS-232 SERIAL COMMUNICATIONS COMMANDS
Switching/Routing Binary Table
ASCII | Input | Output | ASCII | Input | Output | |
Command | Command | |||||
|
|
|
| |||
A1/a1 | 1A | 1 | C1/c1 | 1A | 3 | |
A2/a2 | 1B | 1 | C2/c2 | 1B | 3 | |
A3/a3 | 2A | 1 | C3/c3 | 2A | 3 | |
A4/a4 | 2B | 1 | C4/c4 | 2B | 3 | |
A5/a5 | 3A | 1 | C5/c5 | 3A | 3 | |
A6/a6 | 3B | 1 | C6/c6 | 3B | 3 | |
A7/a7 | 4A | 1 | C7/c7 | 4A | 3 | |
A8/a8 | 4B | 1 | C8/c8 | 4B | 3 | |
B1/b1 | 1A | 2 | D1/d1 | 1A | 4 | |
B2/b2 | 1B | 2 | D2/d2 | 1B | 4 | |
B3/b3 | 2A | 2 | D3/d3 | 2A | 4 | |
B4/b4 | 2B | 2 | D4/d4 | 2B | 4 | |
B5/b5 | 3A | 2 | D5/d5 | 3A | 4 | |
B6/b6 | 3B | 2 | D6/d6 | 3B | 4 | |
B7/b7 | 4A | 2 | D7/d7 | 4A | 4 | |
B8/b8 | 4B | 2 | D8/d8 | 4B | 4 |
EDID Management Modes
Use the ASCII commands below to change the EDID modes. For a description of each mode please see page10.
ASCII | EDID Mode | ASCII | EDID Mode |
m0 | 0 | m5 | 5 |
m1 | 1 | m6 | 6 |
m2 | 2 | m7 | 7 |
m3 | 3 | m8 | 8 |
m4 | 4 | mA | A |
IR Remote Channel Configuration
All DIP switches inside the unit must be in their default OFF position. Use the ASCII commands below to change the IR code channel. Please ensure that the IR remote channel on the
ASCII | Remote Channel |
r1 | 1 |
r2 | 2 |
r3 | 3 |
r4 | 4 |
13
