Section 2 – Operation
2.5 WATTAGE REFERENCE GUIDE
Device . . . . . . . . . . . . . . . . . . . . . . . . . . . . .Running Watts *Air Conditioner (12,000 Btu) . . . . . . . . . . . . . . . . . . . . .1700 *Air Conditioner (24,000 Btu) . . . . . . . . . . . . . . . . . . . . .3800 *Air Conditioner (40,000 Btu) . . . . . . . . . . . . . . . . . . . . .6000 Battery Charger (20 Amp) . . . . . . . . . . . . . . . . . . . . . . . .500 Belt Sander (3") . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1000 Chain Saw . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1200 Circular Saw
Device | Running Watts |
Hedge Trimmer | . . . . . . . . .450 |
Impact Wrench | . . . . . . . . .500 |
Iron | . . . . . . . .1200 |
*Jet Pump | . . . . . . . . .800 |
Lawn Mower | . . . . . . . .1200 |
Light Bulb | . . . . . . . . .100 |
Microwave Oven | . . .700 to 1000 |
*Milk Cooler | . . . . . . . .1100 |
Oil Burner on Furnace | . . . . . . . . .300 |
Oil Fired Space Heater (140,000 Btu) | . . . . . . . . .400 |
Oil Fired Space Heater (85,000 Btu) | . . . . . . . . .225 |
Oil Fired Space Heater (30,000 Btu) | . . . . . . . . .150 |
*Paint Sprayer, Airless (1/3 HP) | . . . . . . . . .600 |
Paint Sprayer, Airless (handheld) | . . . . . . . . .150 |
Radio | . . . . .50 to 200 |
*Refrigerator | . . . . . . . . .700 |
Slow Cooker | . . . . . . . . .200 |
*Submersible Pump | . . . . . . . .2800 |
*Submersible Pump (1 HP) | . . . . . . . .2000 |
*Submersible Pump (1/2 HP) | . . . . . . . .1500 |
*Sump Pump | . . .800 to 1050 |
*Table Saw (10") | . .1750 to 2000 |
Television | . . . .200 to 500 |
Toaster | . .1000 to 1650 |
Weed Trimmer | . . . . . . . . .500 |
*Allow 3 times the listed watts for starting these devices. |
• Above 40°F, use SAE
2.6BEFORE STARTING THE GENERATOR
Prior to operating the generator, engine oil and gasoline will need to be added, as follows:
2.6.1 ADDING ENGINE OIL
NOTE: When adding oil to the engine crankcase in the future, use only high quality detergent oil rated with API service classification SF or SG SAE 30 weight. Use no special additives.
Select the oil’s viscosity grade according to the expected operating temperature. Do not use SAE
• Below 40°F, use synthetic
Although
•Place generator on a level surface.
•Clean area around oil fill and remove oil fill cap and dipstick.
•Wipe dipstick clean.
•Slowly fill engine with oil through the oil fill opening until it reaches the full mark on the dipstick. Stop filling occasionally to check oil level. DO NOT OVERFILL.
•Install dipstick. Install oil fill cap and finger tighten securely.
|
|
|
|
|
|
|
| ||
| Synthetic |
|
|
|
|
| |||
ºF | 0 |
| 20 | 32 | 40 |
| 60 | 80 | 100 |
ºC |
| 0 |
| 10 | 20 | 30 | 40 |
Temperature Range of Expected Use
• Check engine oil level before starting each time thereafter.
10