Before You Begin
Carefully read and follow all of the procedures and safety precautions detailed in the installation guide. If you do not completely understand any portion of the installation manual, technical manual or other
Fully comply with all relevant NEC, NFPA and OSHA standards as well as all federal, state and local building and electric codes. As with any generator, this unit must be installed in accordance with current NFPA 37 and NFPA 70 standards as well as any other federal, state, and local codes for minimum distances from other structures.
Contact the local inspector or city hall to make sure you are aware of all state and local codes and regulations that could impact installation. Secure all required permits before starting the job.
Site Preparation & Generator Placement
Locate the mounting pad as close as possible to the transfer switch and fuel supply.
Leave adequate room around the pad for service access (check local code) and place the pad high enough to keep rising water from reaching the generator.
Choose an open space that will provide adequate and unobstructed airflow.
Place the unit so air vents won’t become clogged with leaves, grass, snow or debris. Make sure exhaust fumes will not enter the building through eaves, windows, ventilation fans or other air intakes.
Dig a rectangular area approximately five inches deep and about six inches longer and wider than the footprint of the generator. Cover with polyurethane film and fill with pea gravel or crushed stone. Compact and level the stone.
Inspect the generator for shipping damage and, if necessary, file a claim with the shipper.
Remove the bolts holding the generator base frame to the wooden pallet.
