Service & Repair Manual
Final Inspection:
When each part has been completely cleaned and dried, it must be closely inspected to ensure the total absence of contamination or cleaner residue. In the event that contamination is still found during inspection, it may be necessary to
1.Gently wipe all surfaces of each part with a clean,
2.Assuming no contamination is found, immediately inspect the same part and wipe under ultraviolet light to check for any signs of oils, grease, or fine particulate matter which will fluoresce (glow) if present. If found, repeat the aqueous cleaning procedure.
NOTE: Isolated particles of dust may be eliminated with low pressure,
3.Wrap or cover all metal parts with cellophane or other plastic until ready to begin reassembly.
NOTE: Before proceeding, clean fingertips of latex gloves with isopropyl alcohol to remove any contamination.
4.Examine each replacement parts kit to determine that it has not been previously opened, and that the individual parts have not been ex- posed to possible contamination, including handling with bare fingers.
WARNING: Do not attempt to use individually ordered spare parts as a substitute for those packaged in kit form directly from Genesis Scuba. Doing so will render the product incompatible for use with enriched air, and may seriously jeopardize the safety of the diver.
5.Closely inspect all new replacement parts for both the first and second stage, including
21 | Copyright ©2001 Liberty Group |
