Second Edition • Fourth Printing | Operator’s Manual |
|
|
|
|
Transport Instructions
Observe and Obey:
Common sense and planning must be applied to control the movement of the machine when lifting it with a crane or forklift.
The transport vehicle must be parked on a level surface.
The transport vehicle must be secured to prevent rolling while the machine is being loaded.
Vehicle capacity, loading equipment and surfaces must be capable of supporting the machine weight. See Specifications section.
The base of the machine must remain lowered during all loading and transport procedures.
The machine must be secured to the transport vehicle with chains or straps of ample load capacity.
Winching the Machine onto a FlatbedTruck
1Lower the platform.
2Push in the red Emergency Stop buttons, turn the key switch to the OFF position and remove the key.
3Inspect the entire machine for loose or unsecured items.
4Connect the cable to the winching point located on the front of the base.
5Carefully winch the machine onto the truck.
6Secure the machine base and mast to the transport vehicle. Use chains or straps of ample load capacity.
Loading the Machine With a Forklift
Use the forklift pockets located on the sides of the machine or the forklift rings located behind the counterweight under the platform.
Be sure to inspect the machine and remove any loose or unsecured items.
To use the forklift rings:
1Raise the platform 3 inches / 7.5 cm.
2 Position the forklift rings in the up position.
Loading the Machine With a Crane
Use the lifting eye mounted on the rear mast column.
The battery pack must be removed before lifting the machine with a crane.
Be sure to inspect the machine and remove any loose or unsecured items.
Always place the lifting hook through the lifting eye so that it points away from the machine.
Part No.48643 | Genie IWP Super Series | 21 |
