Genie M-4700, M-4500 owner manual Operation of Your Opener, Homelink Transceiver

11. OPERATION OF YOUR OPENER

Your opener can be activated via any of the following, depending on which accessories your opener system has:

■Remote Control Transmitter

■Wall Control Panel

■Doorbell-Type Pushbutton

■Keyless Entry (optional accessory p.28)

REMOTE CONTROL TRANSMITTER:

■To open or close garage door, press and hold button (Midi transmitter has an indicator light that will start blinking). See Fig. 51A. When garage door begins to move, release button.

■To stop garage door during travel, press and hold button until door stops, then release button.

■To resume garage door travel after stopping it, press and hold button until door begins to move, then release button.

WALL CONTROL PANEL:

■The illuminated Door Pushbutton will light when properly connected (if it does not light up, review section 8-11. “Install Wall Control” on page 14 or refer to “Having a Problem” on page 29).

■To open or close garage door, press and hold Illuminated Door Pushbutton. See Fig. 51B. When garage door begins to move, release button.

■To stop garage door during travel, press and hold button until door stops, then release button.

■To resume garage door travel after stopping it, press and hold button until door begins to move, then release button.

■The Light On /Off button can be used to turn lights on or off. Press light On /Off button until lights come on or turn off. Release button. When using the light On /Off button, the automatic timer is ignored, and the lights will remain on until the button is pressed again, or until the opener is activated and the automatic timer begins again.

■The Lock/Vacation button can be used to lock out all remote control transmitters. The door can still be acti- vated by wall control panel or keyless entry system. Press and hold Lock/Vacation button for 2-3 seconds. Release button. Illuminated Door Pushbutton will flash continuously while lock mode is active. To unlock opener, press and hold Lock/Vacation button for 2-3 seconds.

DOORBELL-TYPE PUSHBUTTON:

■To open or close garage door, press and hold Pushbutton. See Fig. 51C. When garage door begins to move, release button.

■To stop garage door during travel, press and hold button until door stops, then release button.

■To resume garage door travel after stopping it, press and hold button until door begins to move, then release button.

OPENER LIGHTS:

■Lights will come on whenever opener is activated. Lights will stay on for 4 minutes and 15 seconds, or until the Light On /Off button on the wall control panel is pressed, whichever is sooner.

■Lights can be turned on and off manually as described under operation of wall control panel.

■Lights will flash when the opener senses an obstruction either detected by the internal safety system or the photo eye. To stop lights from flashing, remove obstruction and operate door normally.

Fig. 51

A. 2-Channel Midi Transmitter

Indicator Light
Buttons
B. Wall Control Panel	C. Doorbell-Type Pushbutton
	Pushbutton

Lock/Vacation

Button

Light On/Off

Button

Illuminated

Door Pushbutton

12. HOMELINK® TRANSCEIVER

Before you can use your car’s HomeLink® device to open a garage door you must transfer an active code from the transmitter to the HomeLink® Universal Transceiver. (Reference - HomeLink® Manual)

23