Genie TML-4000 manual Setup, Install the Lamp Fixtures if applicable, Test the Machine Functions

Operator's Manual Third Edition • Second Printing

FUNCTION TESTS

Setup

1Position the machine at the desired work site.

2Disconnect the trailer lights and safety chains.

3Open the latch on the coupler.

4Pull the release pin on the tongue outrigger and rotate the outrigger towards the ground until the outrigger pin locks securely in place.

5Turn the jack handle to lower the outrigger foot pad and raise the tongue of the machine enough to clear the tow vehicle.

6Release the spring pin on the side outriggers and lower them to the ground. Make sure the locking arms are locked in place.

7Turn the outrigger jack handles to level the machine. Level the machine using only the leveling jacks.

Install the Lamp Fixtures (if applicable)

For each lamp fixture:

8Remove the lamp fixture from the storage location under the covers.

9Slide the fixture into the holes on the mounting bracket and close the latches.

10Insert and close the safety pins.

11Remove the cap from the receptacle socket and connect the electrical plug.

Note: Make sure the safety pins are properly installed before raising the mast.

Test the Machine Functions

By raising and extending, then retracting and lowering the mast back to the horizontal position, the following functions will be tested: winches, latches, mast extension and mast rotation.

12 Unlock the mast hold-down latch.

13Turn the raise/lower winch handle clockwise until the mast raises approximately 2 feet /

60 cm.

Result: A clicking sound should be heard as the winch handle is turned.

14 Release the winch handle.

Result: The winch brake should hold when the handle is released.

15 Continue to turn the winch handle clockwise until the mast reaches full vertical position.

Result: The mast should raise smoothly, free of hesitation or binding.

Result: The spring latch on the front of the machine should lock the mast securely into place.

16Turn the extend/retract winch handle clockwise until the mast extends approximately 2 feet / 60 cm.

Result: A clicking sound should be heard as the winch handle is turned.

Result: The mast sections should telescope smoothly, free of hesitation or binding.

17 Release the winch handle.

Result: The winch brake should hold when the handle is released.

14 Genie TML-4000 andTML-4000N Part No. 97600