![Collision Hazard](/images/new-backgrounds/85383/853839x1.webp)
Third Edition • Second Printing | Operator's Manual | |
|
|
|
|
|
|
Keep away from the machine if it contacts energized power lines. Personnel must not touch or operate the machine until power lines are shut off.
Do not connect wires directly to the generator. Connect auxiliary equipment only to the power outlets provided.
Inspect the power cord for damage prior to each use. Replace any damaged cord before operating.
Do not allow the power cord to become caught or crushed while raising, lowering or rotating the mast.
Avoid electrical shock from contact with battery terminals. Remove all rings, watches and other jewelry.
This machine should be grounded in accordance with all local electrical codes. Consult the local electrical codes or Authority Having Jurisdiction in the area where the machine will be used for specific requirements.
Collision Hazard
Check the work area for overhead obstructions or other possible hazards.
Bodily Injury Hazard
Do not grasp the cable.
Use proper lifting techniques when lifting and positioning the tongue of the machine.
Always replace the protective lamp cover after replacing the lamp bulbs.
SAFETY RULES
Burn Hazard
Do not touch the lamp fixtures while they are turned on. Turn the lamps off and allow them to cool before touching.
Crushing Hazards
Do not lower the mast unless the area below is clear of personnel and obstructions.
Do not release the spring latch on the side of the machine unless the mast sections are fully retracted.
Keep hands and fingers away from any potential pinch points.
Damaged Machine Hazards
Do not use a damaged or malfunctioning machine.
Do not use a machine with a worn, frayed, kinked or damaged cable.
Be sure the operator's manual is complete, legible and in the storage container located on the machine.
Be sure all decals are legible and in place.
Part No. 97600 | Genie | 3 |