Third Edition • Second Printing | Operator's Manual | |
|
|
|
|
|
|
18Press and hold the mast rotation lever.
19Rotate the mast clockwise and then counterclockwise as far as it will go in either direction.
Result: The mast should rotate smoothly and easily in both directions.
20 Rotate the mast back to its original position. Line up the black arrows on the front of the mast.
21Release the mast rotation lever.
22Attempt to rotate the mast in both directions. 
Result: The mast should not rotate.
23Turn the extend/retract winch handle counterclockwise until the mast sections are fully retracted. Line up the blue arrows on the side of the mast.
Result: No clicking sound should be heard when the winch handle is turned.
24 Pull and hold the mast release latch below the control panel.
25 Begin lowering the mast to the horizontal position by turning the raise/lower winch handle counterclockwise and holding the release latch open.
Result: No clicking sound should be heard when the winch handle is turned.
26 Release the mast release latch and continue to crank the winch handle counterclockwise until the mast reaches horizontal position.
Note: Make sure the mast is lowered completely into the transport cradle. Follow the mast stowing instructions in the Operating Instructions section to make sure the mast
FUNCTION TESTS
Test the Lights
27Make sure the circuit breaker light switches are in the off position.
28Start the engine. See Starting the Engine in the Operating Instructions section.
29Turn all four circuit breaker light switches to the on position.
Result: The lights should come on.
Note: It can take up to 20 minutes for the lights to reach full intensity. If the lights are turned off and turned back on while they are still warm, they will not light up again for
Note: Make sure the circuit breaker light switches are turned off before shutting down the engine.
Part No. 97600 | Genie | 15 |
