Genie TML-4000 Workplace Inspection, Inspect the workplace, Do Not Operate Unless, Fundamentals

Operator's Manual Third Edition • Second Printing

Workplace Inspection

Do Not Operate Unless:

You learn and practice the principles of safe machine operation contained in this operator's manual.

1Avoid hazardous situations.

2Always perform a pre-operation inspection.

3Always perform function tests prior to use.

4Inspect the workplace.

Know and understand the workplace inspection before going on to the next section.

5Only use the machine as it was intended.

Be aware of and avoid the following hazardous situations:

·Drop-offs or holes

·Bumps and obstructions

·Debris

·Slopes that exceed the machine’s leveling capability

·Unstable or slippery surfaces

·Overhead obstructions and high voltage conductors

·Hazardous locations

·Inadequate surface support to withstand all load forces imposed by the machine

·Wind and weather conditions

·The presence of unauthorized personnel

·All other possible unsafe conditions

Fundamentals

The workplace inspection helps the operator determine if the workplace is suitable for safe machine operation. It should be performed by the operator prior to moving the machine to the workplace.

It is the operator's responsibility to read and remember the workplace hazards, then watch for and avoid them while moving, setting up and operating the machine.

16 Genie TML-4000 andTML-4000N Part No. 97600