Genie TML-4000 manual To Raise the Mast, To Extend the Mast, To Rotate the Mast, To Stow the Mast

Operator's Manual Third Edition • Second Printing

OPERATING INSTRUCTIONS

To Raise the Mast

1Unlock the mast hold-down latch.

2Turn the Raise/Lower winch handle clockwise until the mast reaches the full vertical position and the front spring latch locks the mast firmly in place.

To Extend the Mast

1Turn the Extend/Retract winch handle clockwise to extend the mast sections.

2Approximately 6 inches / 15 cm below full mast extension, the lamp fixture will begin to tilt. The more the winch handle is turned, the greater the tilt, until the mast is fully extended and the lights are positioned.

Note: To adjust the lights after the mast is fully extended, slowly lower the mast by turning the winch handle counterclockwise until the lights are in the desired position.

To Rotate the Mast

1Press and hold the mast rotation lever and rotate the mast to the desired position.

2Release the lever.

To Stow the Mast

1Press and hold the mast rotation lever and rotate the mast to its original position. Line up the black arrows on the front of the mast.

2Turn the Extend/Retract winch handle counterclockwise until the mast sections retract. The mast is fully retracted when the blue arrows on the side of the mast are lined up.

3Pull and hold the mast release latch below the control panel.

4Turn the Raise/Lower winch handle counterclockwise and lower the mast completely into the transport cradle.

Note: If the mast has not been fully retracted, it will not rest completely in the cradle.

5Turn the mast hold-down latch handle counterclockwise and push into the lock.

6Turn the latch handle clockwise until the handle points straight down. The latch should turn freely without binding or hesitation.

Grounding Rod Attachment

A grounding rod attachment is located next to the generator under the cover on the control panel side of the machine.

After Each Use

1Select a safe parking location—firm, level surface, clear of obstructions and traffic.

2Remove the key OR lock the control panel to secure from unauthorized use.

To Store the Lamp Fixtures (Standard models)

Note: Do not touch hot lamp fixtures. Make sure the lights are turned off and the lamp fixtures have cooled down before touching.

For each lamp fixture:

1Disconnect the electrical plug and cap the receptacle socket.

2Remove the safety pins and release the latches.

3Pull the lamp fixture up and off the mounting bracket.

4Slide the lamp fixture onto the channels located under the covers.

5Close and secure the covers before transport.

18 Genie TML-4000 andTML-4000N Part No. 97600