Operator's Manual | Second Edition • First Printing |
|
|
|
|
FUNCTION TESTS
Test Outrigger Interlock
23 Place the boom in the stowed position.
24 Push and hold the blue function enable button. Push and hold one outrigger button and raise the outrigger off the ground.
25 Push and hold the blue function enable button and activate each boom function.
Result: All boom functions should not operate.
26 Use the leveling buttons to lower the outrigger.
27 Repeat this procedure for each outrigger.
28 Use the function enable buttons and the auto level button or the outrigger leveling buttons to make sure the machine is level.
29 Raise the platform approximately 2 feet / 60 cm.
30 Push and hold the blue function enable button and attempt to raise each outrigger off the ground.
Result: The outriggers should not raise.
Test the Tilt Sensor
31 Raise the boom 2 feet / 60 cm.
32 Turn the key switch to platform control.
33 Locate the tilt sensor below the ground control box. It is the sensor farthest to the left.
34 Press down one side of the tilt sensor.
Result: The alarm should sound.
35 Lower the boom.
At the Platform Controls
36 Pull out the platform red Emergency Stop button to the on position.
Test Emergency Stop
37 Push in the platform red Emergency Stop button to the off position.
Result: All platform control functions should not operate.
38 Pull out the platform red Emergency Stop button to the on position.
Test Boom Functions and Function Enable
39 Do not push a function enable button. Attempt to activate each boom function button.
Result: All boom functions should not operate.
40 Push and hold the blue function enable button. Activate each boom function button.
Result: Primary boom up, primary boom extend, secondary boom up, platform level up, jib boom up, platform rotate left and turntable rotate left should all function.
41 Push and hold the yellow function enable button. Activate each boom function button.
Result: Primary boom down, primary boom retract, secondary boom down, platform level down, jib boom down, platform rotate right and turntable rotate right should all function.
18 | Genie | Part No. 114164 |
