Genie TZ-50 manual Lifting Instructions, Center of Gravity Table, Axis Chassis Lifting Points

Second Edition • First Printing Operator's Manual

TRANSPORT AND LIFTING INSTRUCTIONS

Observe and Obey:

Only qualified riggers should rig and lift the machine.

Be sure the crane capacity, loading surfaces and straps or lines are sufficient to withstand the machine weight. See the serial plate for the machine weight.

Lifting Instructions

Fully lower and retract the boom.

Securely latch the boom hold-down latches.

Raise all four outriggers to the stowed position.

Remove all loose items on the machine.

Determine the center of gravity of your machine using the table and pictures on this page. Measure from one of the lifting points on the tongue end of the machine.

Attach the rigging only to the designated lifting points on the machine.

Adjust the rigging to prevent damage to the machine and to keep the machine level.

Center of Gravity Table

	X Axis	Y Axis
ANSI, CSA and Australia	13.5 in	16 in
	34 cm	41 cm
CE	12.4 in	16 in
	31 cm	41 cm

Tie-down

point Lifting point

Y axis
Chassis	Chassis
Lifting	Lifting
Points (2)	Points (2)
	X axis

Part No. 114164 Genie TZ-50 31