Version | Giantec 2000 manual

Tracer 2000 DVR user manual

4.Insert the assembled HDD tray into TRACER2000, and connect both Power and HDD cables.

Version 3.0

Page 35 of 36

Image 35

Giantec 2000 manual Version

Contents

User’s Manual Contents Chapter System HDD Installation Guide Copyright Notice Chapter Feature Packing List Package ※Remove and clean up Air Filters monthly is essential Installation Connect VGA Monitor Indicator Version Connect to Printer Port option Power Connector Pin assignment Internal Jumpers and Connectors Power connector P1 Power Switch for ATX power supply JP1Reset/LED/Speaker JP1 Internal USB connector USB2 FAN control FAN1 HDD Connector IDE1CPU FSB Select JP4 Video Input J2 Parallel/Printer connector PRN Infra-Red IR General Purpose Input / Output J3 Component Side PCI bus pin assignment Gpio connector USB connector External Connector CRT Display Connector VGAAudio Input connector COM2 Connector COM 1 Connector RS-232 Connector COM1 Connectors Ethernet connector RJ-45 Drawing of Ethernet connector RJ-45 RS485 RS422 RS232 Z Setting Introduction Setup Pages EGA/VGA Standard Cmos Features Cdrom Advanced Bios Features Advanced Chipset Features Button only Integrated Peripherals Dpms Power Management Setup PnP / PCI Configuration Frequency/Voltage Control PC Health Status Exit Without Save Load Optimized DefaultsSupervisor / User Password Save & Exit Setup System HDD Installation Guide Take off the upper cover and remove the screws Remove HDD Tray, and install HDD properly Version Assemble the upper cover and the screws