Installation Instructions
Step 5: Commissioning
Pressure test point
Use the oven burner. From inside the oven remove the burner cowl. Remove the small screw at the LHS of the burner cradle. Slide the burner to the left to access the injector.
Connect suitable
Replace in reverse order.
Burner aeration
All burners have fixed aeration and no adjustment is possible.
Pressure setting
G20 Natural Gas @ 20 mbar
Electrical systems check
In the event of an electrical fault the preliminary electrical system check (earth continuity, short circuit, polarity and resistance to earth) must be carried out.
Ignition
The automatic ignition continues to spark for a short time after the burner has lit until the flame is established.
Oven (Top and Main)
Push in and turn the main oven control knob anti clockwise to the ‘FULL ON’ position (gas mark 9). The ignition system will spark automatically. Push in the control knob to ignite the gas. The sparking will stop. If after 15 seconds, the burner has not lit, turn off the oven and leave the compartment door open. Wait at least one minute before a further attempt to ignite the burner.
Do not hold the control knob in for more than 15 seconds.
Turn the control knob clockwise to the required setting.
To turn off, return the control knob to the “off” position.
Grill
1.The door must be open for grilling.
2.Push in and turn the control knob clockwise to the grill symbol.
When you first turn on the oven or grill you may notice a smell and some smoke which comes from the protective coating of oil burning off from some of the parts.
Before leaving the installation
Show the customer how to ignite the oven and operate the grill, and give them this handbook. Thank you.
30
