Adjusting the exhaust direction:
1.The finish nailer is equipped with an adjustable direction exhaust deflector (1). Simply adjust the directional exhaust deflector so that the exhaust air blast will be directed away from the operator. Grasp the deflector and rotate it to the desired position for the current application.
Adjusting the fastening depth:
1.Regulate the air pressure to 120 PSI at the compressor.
2.Connect the air hose to the nailer and test for penetration by driving fasteners into a sample piece of wood. If the fasteners do not achieve the desired depth, rotate the depth adjustment thumb wheel (10) until the desired depth is achieved.
Clearing a jam:
1.Disconnect the air supply from the nailer and remove all fasteners from the magazine.
2.Press the quick release latch
(9) which will disengage the driver safety cover (8). Remove the driver safety cover (8) so the jammed fastener is exposed.
3.Remove the jammed fastener, using screwdriver or long nose pliers if required.
4.Close back the driver safety cover tightly.
5.Test the finish nailer.
Air source
This tool is designed to operate on clean, dry, compressed air at regulated pressures between 75 and 120 PSI.
The preferred system would include a filter, a pressure regulator, and an automatic oiler located as close to the tool as possible.
All compressed air contains moisture and other contaminates that are detrimental to internal components of the tool. An air line filter will remove most of these contaminates and significantly prolong the life of the tool. If an
DANGER. All air line components (hoses, connectors, filters, regulators, etc.) must have a minimum working pressure rating of at least 120 PSI or 150% of maximum system potential, whichever is greater.
14
