Preparing the tool

Tool lubrication

This brad nailer/stapler requires lubrication BEFORE initial use and BEFORE and AFTER each additional use throughout its life.

1.Disconnect the air hose, turn the brad nailer/stapler so the air inlet (3) is facing up. Place 3-4 drops of non detergent oil into the air inlet. Do not use air tool oil as it contains solvents which will damage the nailer/stapler’s internal parts.

2.Lubricate the drive safety cover & slide guide (8), trigger

(2) and magazine slide mechanism periodically.

Apply a few drops of oil to the trigger mechanism.

Apply a thin coat of lightweight grease to safety slide guides.

3.After lubrication, run brad nailer/stapler briefly. Wipe off any excess oil from the adjustable deflector exhaust (1). The work surface can become damaged by excessive lubrication.

4.Brad nailer/stapler repairs must be done by a qualified and experienced service dealer.

Place a few drops of non-detergent oil into air inlet before each use.

Apply a few drops of oil to sliding mechanism of the magazine.

12

Page 27
Image 27
Global Machinery Company ATBR1650-3PK instruction manual Preparing the tool