Global Machinery Company ATBR1650-3PK instruction manual Preparing the tool, Tool lubrication

Preparing the tool

Tool lubrication

This finish nailer requires lubrication BEFORE initial use and BEFORE and AFTER each additional use throughout its life.

1.Disconnect the air hose, turn the finish nailer so the air inlet (3) is facing up. Place 3-4 drops of non detergent oil into the air inlet. Do not use air tool oil as it contains solvents which will damage the nailer’s internal parts.

2.Lubricate the drive safety cover & slide guide (8), trigger

(2) and magazine slide mechanism periodically.

Apply a few drops of oil to the trigger mechanism.

Apply a thin coat of lightweight grease to safety slide guides.

3.After lubrication, run brad nailer briefly. Wipe off any excess oil from the adjustable deflector exhaust (1). The work surface can become damaged by excessive lubrication.

4.Finish nailer repairs must be done by a qualified and experienced service dealer.

Place a few drops of non-detergent oil into air inlet before each use.

Apply a few drops of oil to sliding mechanism of the magazine.

12