10
Note. When fitting belts it is
easier to place the belt onto the
small pulley and then turn it onto
the larger pulley.
Unscrew the screw from the
pulley cover knob (21) and
place it through the hole on the
right side of the pulley cover (1)
and tighten.
To apply tension to the belt, loosen the belt tension lock knob
(2) and push the motor housing backwards. Tighten belt
tension lock knob.
Replace and secure the pulley cover.
Adjusting the table height
CAUTION. Always ensure that the
drill press is switched off and the
plug is removed from the power
point before making
any adjustments.
Loosen the support lock (9).
Rotate the handle in an anti-clockwise direction to loosen
the table support (10).
Raise/Lower the table support
to the desired height.
Tighten the support lock to
secure the table.
Adjusting the table angle
CAUTION. Always ensure that the drill press is switched off
and the plug is removed from the power point before making
any adjustments.
Loosen the screw under the table by rotating it in an anti-
clockwise direction.
Tilt the table to the desired angle as indicated on the bevel
scale.
Tighten the screw under the table by rotating it in a clockwise
direction.