necessary. A Phillips #1 screwdriver (not supplied) is needed during the assembly.
1.Place the wire stand to the bottom of the handle, ensuring that the ends of the stand align themselves with the holes on the handle.
2.Insert the Phillips screw on one side between the end of the stand and the
hole of the handle. Use the Phillips screwdriver to secure the screw.
3.Repeat this process on the other side of the handle.
Note: Before you commence with the assembly, make sure that the plug of the unit is disconnected from the mains supply.
Unpacking
Due to modern mass production techniques, it is unlikely that your GMC Power Tool is faulty or that a part is missing. If you find anything wrong, do not operate the tool until the parts have been replaced or the fault has been rectified. Failure to do so could result in serious personal injury.
8
