Compass Owner’s Manual – Models # : GP600 SS, GP600 CC, GP601 SS, GP601 CC | Revised 02/20/08 |
ASSEMBLY
SEAT REMOVAL/INSTALLATION
Note: The seat assembly weighs about 48 pounds. Please ask for help if you do not feel capable of safely lifting that much weight. Removal of arms will significantly reduce the weight of seat.
REMOVAL
1. Disconnect the controller cable from the joystick. “Unclip” from arm and remove Velcro®
See figure 2 on page 11.
2. Lift the front and rear seat lock handles and slide the seat until all (4) of the seat guides are out of the receivers.
INSTALLATION
The seat can be installed from either side of the power chair.
1.To install the seat, align the seat guides (front and rear) with the seat receivers (front and rear).
2.Slide the seat towards the center of the power chair until the seat locks securely in place. The front and rear locks must engage.
3.Reconnect the controller cable to the joystick cable.
BE SURE THE SEAT IS CORRECTLY INSTALLED AND LOCKED BEFORE OPERATING YOUR POWER CHAIR.
Front Seat Lock
Handle
Rear Seat Lock
Handle
Rear Seat Lock
Handle
Figure 3
Seat Locking
Handle
Seat Height &
Angle
Adjustment Pins
Figure 4
Front Seat Lock
Handle
Seat Guides
Seat Receiver
Figure 5 | Figure 6 |
13
