13.Press two 25mm Round Inner Caps (70) into two Weight Rests (39). Insert the Weight Rests into the Right Upright (4) and engage the locking bars around the Upright.
Repeat this step with the other Weight Rests (39) and the Left Upright (not shown).
14.Press three 45mm Square Inner Caps (34) into the Leg Lever (18). Press a 25mm Round Inner Cap (70) into the Weight Tube (19).
Attach the Weight Tube (19) to the Leg Lever (18) with an M8 x 57mm Bolt (68), two M8 Washers (63), a 12mm x 10mm Spacer (61), and an M8 Nylon Locknut (64). Press the 25mm Round Outer Cap (62) onto the end of the Weight Tube.
15.Lubricate an M10 x 70mm Bolt (55) with grease. Attach the Leg Lever (18) to the Front Leg (12) with the Bolt and an M10 Nylon Locknut (58). Do not overtighten the Locknut; the Leg Lever must be able to pivot easily.
16.Press two 19mm Round Inner Caps (25) into the ends of a Pad Tube (24). Slide a Pad Tube through a hole in the Front Leg (12). Slide two Foam Pads (23) onto the Pad Tube.
Repeat this step with other Pad Tubes (24) and the Leg Lever (18).
13 |
|
|
|
|
|
| 39 |
| 4 |
|
|
| 70 | 70 | Locking |
|
| ||
| 39 | Bars | |
|
| ||
| Locking |
|
|
| Bars |
|
|
14 |
| 34 |
|
|
|
| |
| 64 |
|
|
| 61 |
| 18 |
|
|
| |
| 63 |
| 62 |
|
|
| 63 |
| 34 |
| 68 |
| 19 | 34 | |
|
| ||
| 70 |
|
|
15 | 58 |
|
|
|
|
| |
| 18 | 12 |
|
|
|
| |
|
| 55 | Lubricate |
|
|
| |
16 | 23 |
|
|
| 25 |
|
|
| 18 | 12 |
|
|
|
| |
|
|
| 24 |
| 24 | 24 |
|
|
|
| 25 |
|
|
| 23 |
10
