21.Press a 45mm Square Inner Cap (34) into the top of the Lat Tower (15).
Route the Cable (33) over the 90mm Pulley (45), through the Lat Tower (15), and under the hook. Attach the Pulley inside the Lat Tower with an M10 x 60mm Bolt (76), two M10 Washers (43), two 15mm x 10mm Spacers (44), and an M10 Nylon Locknut (58).
Attach the Weight Clip (71) to the end of the Cable (33) as shown.
22.Press two 25mm Round Inner Caps (70) into the Weight Carriage (14). Insert an M10 x 20mm Bolt
(51)into the Weight Carriage (14) as shown.
Slide the Weight Carriage (14) onto the Lat Tower (15) as shown.
Attach the Cable (33) to the Weight Carriage (14) with the M10 x 20mm Bolt (51) and an M10 Nylon Locknut (58).
23.Make sure that all parts are properly tightened before you use the weight bench. The use of all remaining parts will be explained in ADJUSTMENTS starting on the next page.
21 |
|
|
58 | 34 |
|
|
| |
44 | Hook | 33 |
| ||
43 |
|
|
|
| 71 |
45 | 44 |
|
| 43 |
|
|
| 76 |
| 15 |
|
22 |
|
|
| 15 |
|
33 |
|
|
58 |
| 51 |
|
| |
70 | 14 |
|
|
| |
|
| 70 |
12
