Gold's Gym GGTL04607.1 See the left inset drawing. Identify the two, Fully tighten the Bolt yet

5. Raise the Uprights (31, 36) so that the Base (48)	5	28
is flat on the floor and positioned as shown.
Cut the tie holding the Upright Wire (28) in a bun-		Wire Tie
dle.		31	36	28
See the far right drawing. Wrap the wire tie in the
Right Upright (36) around the end of the Upright			Large
Wire (28). Then, pull the other end of the wire tie
until the Wire Harness is extending from the			Hole
upper end of the Right Upright.				Wire
Make sure that the end of the Upright Wire
(28) does not fall into the Right Upright (36).			48	Tie
6. Raise the Uprights (31, 36).	6	31
See the left inset drawing. Identify the two				36
Frame Spacers (34). Open the included packet
of grease, and apply grease to both sides of both
Frame Spacers. Then, identify the outer side of
each Frame Spacer.			47
Hold the Frame Spacer (34) between the Right				34
Upright (36) and the Lift Frame (59), with the
outer side of the Frame Spacer facing the				33
Right Upright. Attach the Right Upright to the					32
Lift Frame with a 3/8" x 3" Bolt (32), a 3/8" Flat		59
Washer (33), and a 3/8" Locknut (47); do not
fully tighten the Bolt yet.
	34		47	Top View
		Outer		36
		Side		33	32
		Inner
			34
		Side
			59
	8