Remove the three indicated #8 x 3/4" Screws (1), and |
|
|
|
|
remove the Motor Hood (58). |
| 58 | 1 | 1 |
|
| |||
Next, locate the Reed Switch (62) and the Magnet | Top | Hole |
|
|
(48) on the left side of the Pulley (47). Turn the Pulley |
|
| ||
until the Magnet is aligned with the Reed Switch. | View |
|
|
|
Make sure that the gap between the Magnet and |
|
|
| 1/8 in. |
the Reed Switch is about 1/8 in. (3 mm). If neces- |
|
|
| |
sary, carefully insert a slotted screwdriver into the in- |
|
|
| 47 |
dicated hole and move the Reed Switch slightly. |
| 62 |
| 48 |
Reattach the Motor Hood (not shown) with the five #8 |
|
| ||
x 3/4" Screws (not shown). Run the treadmill for a few |
|
|
|
|
minutes to check for a correct speed reading. |
|
|
|
|
PROBLEM: The incline of the treadmill does not change correctly |
|
|
|
|
SOLUTION: a. Hold down the Stop button and the Speed increase button, insert the key into the console, and | ||||
then release the Stop button and the Speed increase button. Press the Incline increase or de- | ||||
crease button. The treadmill will automatically rise to the maximum incline level and then return to | ||||
the minimum level. This will recalibrate the incline system. If the incline does not calibrate, press | ||||
the Stop button, and then press the Incline increase or decrease button again. When the incline is | ||||
calibrated, remove the key from the console. |
|
|
|
|
PROBLEM: The walking belt slows when walked on |
|
|
|
|
SOLUTION: a. Use only a | ||||
b. If the walking belt is overtightened, treadmill perfor- | b |
|
| |
mance may decrease and the walking belt may be- |
|
| ||
come damaged. Remove the key and UNPLUG THE |
|
|
|
|
POWER CORD. Using the hex key, turn both idler |
|
|
|
|
roller bolts counterclockwise, 1/4 of a turn. When the |
|
|
|
|
walking belt is properly tightened, you should be able |
|
|
|
|
to lift each edge of the walking belt 3 to 4 in. (8 to 10 |
|
|
|
|
cm) off the walking platform. Be careful to keep the |
|
|
|
|
walking belt centered. Then, plug in the power cord, |
|
|
|
|
insert the key, and run the treadmill for a few minutes. | Idler Roller Bolts |
|
| |
Repeat until the walking belt is properly tightened. |
|
| ||
c. If the walking belt still slows when walked on, please see the front cover of this manual. | ||||
26
