Installation
General Information
NOTE: Reference numbers and letters in parentheses in the text refer to the callouts in the figures and the parts drawings.
NOTE: If you supply your own accessories, be sure they are adequately sized and
Fig. 2 is only a guide for selecting and installing sys- tem components and accessories. Contact your Graco distributor for assistance in designing a system to suit your particular needs.
System Accessories
WARNING
Two accessories are required in your system: a
The
The fluid drain valve assists in relieving fluid pres- sure in the displacement pump, hose, and gun. Triggering the gun to relieve pressure may not be sufficient.
Air and Fluid Hoses
Be sure all air and fluid hoses are properly sized and
Mounting Accessories
Mount the pump (A) to suit the type of installation planned. The pump dimensions and mounting hole layouts are shown on pages 28 and 29.
The Typical Installation on page 7 shows the pump
(A)mounted on a pneumatic elevator cart (B). The pump may also be mounted on a 19 liter (5 gal.) pail ram. In either case, it is used with a wiper plate (C). Refer to the separate manuals for the cart, ram, and wiper plate for further information.
Kits 223881 and 224829 are available to mount the pump on a 200 liter (55 gallon) ram. Refer to the separate manuals included with the kits for further information.
Air Line Accessories
Install the following accessories as shown in Fig. 2, using adapters as necessary:
DA pump runaway valve (G) senses when the pump is running too fast and automatically shuts off the air to the motor. A pump which runs too fast can be seriously damaged. Install closest to the pump air inlet.
DAn air line lubricator (H) provides automatic air motor lubrication.
DA
DAn air regulator (K) controls pump speed and outlet pressure by adjusting the air pressure to the pump. Locate the regulator close to the pump, but upstream from the
DAn air line filter (L) removes harmful dirt and moisture from the compressed air supply.
DA second
DAn air line quick disconnect coupler (F) is required for pumps mounted on the pneumatic elevator cart. The female coupler attaches to the end of the air hose (D), and the male coupler screws into the air manifold (E). See the separate cart manual for further information.
308200 5