Operation
Dispensing Fluid in Auto Mode
CAUTION
Before you begin a preset dispense cycle, make sure AUTO is displayed. If you do not see AUTO on the display, you are not in the Auto dispense mode, and fluid flow will not stop when the auto preset amount is dispensed.
1. Press the Auto/Reset button.
The display wakes up if it was asleep, and AUTO and the stored preset dispense amount are displayed. The factory default is 0.00.
NOTE: To change the stored preset dispense amount, see Auto Preset Amount on page 9.
2.You can dispense or change the displayed preset amount by doing one of the following:
DGo straight to step 3 to dispense the displayed preset amount.
OR
DTo change the displayed preset amount, you can set the display to zero by pressing the Auto/Reset button, then press the10 button to change the 10s digit, press the 1.0 button to change the 1s digit, and press the 0.1 button the change the first decimal digit. Then go to step 3.
3.Lock the trigger. See Locking and Unlocking the Trigger on page 11.
Fluid flows, and the displayed dispensed amount counts up from zero. When the preset amount is dispensed, the unit beeps, the trigger unlocks, fluid flow stops, the dispensed amount is displayed, and the meter switches to the Manual dispense mode.
If you want to stop fluid flow before the preset amount is dispensed, manually unlock the trigger. To continue the dispense, lock the trigger, and the dispensed amount resumes counting toward the preset amount.
If you want to continue dispensing after the trigger unlocks at the preset dispense amount, squeeze the trigger, and the dispensed amount resumes counting in the Manual dispense mode until you release the trig- ger.
NOTE: When the trigger unlocks, the automatic nozzle prevents the fluid in the extension from running out.
12 309377
Viewing Totals
This is the procedure for viewing the
1.If the display is blank, press the Manual/Reset or Auto/Reset button to wake it up.
2.Press the Total button to view the
If the unit of measurement is gallons, quarts, or pints, the total is displayed in gallons, as shown below. If the unit of measurement is liters, the total is displayed in liters.
GAL
TOTAL
! CAUTION
To prevent overfills and spills
D Do not obstruct the trigger D Do not operate below 32_ F (0_ C) D Do not leave unattended D Read instruction manual
Maximum Working Pressure 7 MPa (70 bar, 1000 PSI)
06044A
3.Press the Total button again to view the resettable total amount.
If the unit of measurement is gallons, quarts, or pints, the resettable total is displayed in gallons, as shown below. If the unit of measurement is liters, the reset- table total is displayed in liters.
GAL
! CAUTION
To prevent overfills and spills
D Do not obstruct the trigger D Do not operate below 32_ F (0_ C) D Do not leave unattended D Read instruction manual
Maximum Working Pressure 7 MPa (70 bar, 1000 PSI)
06044A
Pressing the Total button repeatedly toggles between the
4.Press the Manual/Reset or Auto/Reset button to return to the Manual or Auto dispensing mode.
