Graco 246601, 2525LD, 2626LD Installation, Connect High-Pressure Hose and Gun, Install Spray Tip

Installation

Connect High–Pressure Hose and Gun

Connect high–pressure hose between the pump outlet and gun inlet. Both of these connections are made with quick couplers.

Note: Adapter kit 249101 can be used to connect two high pressure hoses together.

ti3457a

ti7345a

Install Spray Tip

Install spray tip on wand. Installing and Changing Spray Tips, page 12). If you are using a Sandblasting Kit, see its separate manual for installation instructions.

ti3228a

Connect to Water Supply

Connect hose with at least a 3/4 in. (19 mm) ID from water supply to 3/4 in. garden hose inlet on the pressure washer. The supply hose should not be more than 50 ft (15 m) long.

CAUTION

Before you connect garden hose to pres- sure washer, check local plumbing codes regarding cross–connection to water supply. If required, install backflow pre- venter.

If inlet water pressure is over 60 psi (4.1 bar), a regulating water valve must be installed at garden hose connection.

Do not exceed 104° F (40° C) inlet water

temperature.ti3229a

Note: Water source must have a minimum flow rate equal to that of pressure washer.

6309828