Graco 262288, 262300, 258907, 258906, 257100 manual Using Finishing Tools, Corner Finishing

Using Finishing Tools

Using Finishing Tools

3. Use flow control knob (C) to set material flow rate. Turn flow control knob clockwise to increase material flow.

Corner Finishing

ti15681a

1.Attach corner finisher inlet swivel to inline valve controller (JJ) valve using quick-connect clamp (QC) attached to valve.

ti15666a

QC

ti8794a

C

NOTE: Fine flow rate adjustments can be made using “+” and “-” buttons on inline valve controller. Flow rate can only be adjusted relative to position of flow control knob. The fine flow rate can only go down from, and up to the flow control knob setting.

+

-

ti15675a

2.Press pin on top of corner finisher head to install onto handle.

4.Pull trigger and work from top to bottom of vertical angles and from one end to other on ceiling angles.

5.Use drywall knife to detail corner and ceiling angle intersections.

ti15665a

3A0245B 11