Using Finishing Tools
Flat Box Finishing
ti15676a
1.Attach male inlet of box finisher to the
2.Install Box Slide Controller (KK) on box finish handle as shown.
TT
KK
ti15668a
NOTE: The Box Slide Controller Brake (TT) allows the controller to be positioned on the handle. Make sure that the brake is fully loosened when installing the con- troller on the handle.
3.Install flat finish box on handle using attached wing nuts.
4.Use flow control knob (C) to set material flow rate. Turn flow control knob clockwise to increase material flow.
5.Place flat box at end of joint.
6.Pull trigger and lead with handle and draw the tool along the joint.
7.Near middle of the joint, remove flat box from joint surface by applying brake and using a sweeping motion.
8.Adjust hand position and begin again at other end of joint.
9.Again, draw flat box along joint up to previous stopping point and remove box from joint surface by applying brake and using a sweeping motion.
10.Use drywall knife to eliminate seams and overlap.
NOTE: To remove RF Controller, use both thumbs and press down as shown:
ti15673a
C
ti8794a
12 | 3A0245B |