Automatic Taping
1. Remove creaser wheel trigger pin.
ti15679a
2. Attach taper tool to inline valve.
ti15748a
3.Position creaser wheel trigger and insert pin into trigger assembly.
Using Finishing Tools
5.Use flow control knob (C) to set material flow rate. Turn flow control knob clockwise to increase material flow.
ti8794a
C
NOTE: Fine flow rate adjustments can be made using “+” and
+
- 
ti15675a
6. | Place one hand on taper control tube and one hand |
| on Inline Controller Valve (JJ) while in use. |
7. | Place tape at bottom of joint (slide tube forward to |
| feed tape). |
ti15678a | Pull trigger and roll tape over seam keeping taper |
8. | |
| head wheels in contact with wall. |
4. Load tape into taper tool. |
|
9. | When taper reaches approximately 3 in. (7.5 cm) |
| from end of seam, stop completely and pull tube |
| back to cut tape. |
10. | Use drywall knife to detail seams and overlap. |
ti15682a | NOTE: Clean all tools thoroughly after every use. Use |
| a brush and water to remove all joint compound from |
| tools. Once tools have been cleaned, lightly oil using |
| any light machine oil. |
| NOTE: When taping ceilings or corner seams, the |
| creaser wheel can be actuated to push the tape into |
| the seam by using the creaser wheel trigger. |
3A0245B | 13 |
