| Troubleshooting | |
|
|
|
| What to Check | What to Do |
| If check is OK, go to next | When check is not OK, |
Problem | check | refer to this column |
|
|
|
Fluid is spitting from gun | Air in pump or hose. | Check and tighten all fluid |
|
| connections. Cycle pump as slowly as |
|
| possible during priming. |
|
|
|
| Spray tip is partially clogged. | Clear tip. See Clear Tip Clog, page |
|
| 22. |
|
|
|
| Fluid supply is low or empty. | Refill fluid supply. Prime pump. See |
|
| pump manual. Check fluid supply |
|
| often to prevent running pump dry. |
|
|
|
Pump is difficult to prime | Air in pump or hose. | Check and tighten all fluid |
|
| connections. Cycle pump as slowly as |
|
| possible during priming. |
|
|
|
| Intake valve is leaking. | Clean intake valve. Be sure ball seat |
|
| is not nicked or worn and that ball |
|
| seats well. Reassemble valve. |
|
|
|
| Pump packings are worn. | Replace pump packings. See pump |
|
| manual. |
|
|
|
| Paint is too thick. | Thin the paint according to supplier |
|
| recommendations. |
|
|
|
Sprayer operates for 5 to 10 minutes | Pump packing nut too tight. When | Loosen pump packing nut. Check for |
then stops | pump packing nut is too tight the | leaks around throat. If necessary, |
| packings on the pump rod restrict | replace pump packings. See Pump |
| pump action and overloads the motor. | manual. |
|
|
|
334530A | 31 |
