Graco 3A1163A important safety instructions Connect Color Change Module, One Color Change Board

Electrical

Connect Color Change Module

To install the color change module(s), see manual 312787.

Connect a 5-pin electrical cable from the labeled con-

nection port (J11) on the fluid station control board to the color change board. See FIG. 12.

If you are using two color change modules to add colors, connect a 5-pin electrical cable from the first color change board to the second color change board.

Set switches S3-S6 on the color change board(s) as shown in Table 2 and FIG. 12, depending on the number of color change boards and color change modules being used in your system.

For wiring between the color change board and the sole- noids, see the color change module electrical sche- matic, FIG. 13.

Table 2: Color Change Board Switch Settings

Two Color Change Boards

	Color Change Board 1					Color Change Board 2
S3	S6	S5	S4		S3	S6	S5	S4
Termination		Catalyst	Color		Termination		Catalyst	Color	Effect on System
Resistor	Board ID	On/Off	On/Off		Resistor	Board ID	On/Off	On/Off
OFF	ON	OFF	ON		ON	OFF	NOT USED		0 catalyst valves, 30 color
									valves
				One Color Change Board
ON	ON	OFF	ON			NOT USED			0 catalyst valves, 12 color
									valves

24 3A1163A